Rubber Landscape Edging Ideas – Rubber edging trim is popular choice for gardeners because it is more economical than its counterparts bordering expensive as brick and stone. Rubber is important because it keeps the grass from separating into planters. In addition, you can use plastic edges around trees, roads and driveways. Landscaping with rubber trim gives you clear, even lines between surfaces, lawns and garden areas.
Place stakes along the track, driveway or gardening bed where you want to install rubber landscape edging. Drive the stakes on the floor every 2 feet with a rubber or wooden mallet. It can wet the ground if it is difficult to push the stake. Tie a string to each of these bets. Step of the proposed landscape edging route. Move by any stakes that are causing the uniform line to be twisted. If you are following a natural curve in your terrain, make sure the line is not zigzag.
12 Photos Gallery of: Rubber Landscape Edging Ideas
To build rubber landscape edging, measure the proposed edge path with a tape measure. Plastic rim usually comes in 10-foot strips. A few feet more than necessary to be able correct or add the same type of edging in places of purchase. Water the area where you want to install the trim. The soil must be moist but not saturated. Lay the border next to the path and hold it at the top. Hammer the edge through the floor with a wooden or plastic mallet. Hammer the edges along the proposed route. Use string and cuttings as guidelines. Cut any trim with strong garden scissors to fit smaller 10-foot spaces. Step back when finished to inspect the trim and make sure it is where you want it to follow the flower bed or hard surface.